1. In the machining process of precision parts, when the hexagonal wrench is short and cannot withstand pressure, the pipe with an inner diameter slightly larger than the wrench can be inserted into the groove from a part of the milling groove. Inside the slot, it can be used as a long handle. In the CNC machining process in Dongguan, there are many precision parts that are not produced at one time, but when the mechanical parts are produced, it is just a rough model. If the machining factory becomes a real product, it is also processed by some mechanical equipment. According to Different production and processing processes. Processing can eventually become a valuable product.
2. Precision CNC machining, using magnets to absorb small parts (cost) is inconvenient to suck. The iron plate can be sucked under the magnet, which can not only suck a lot of small pieces, but also pull out the iron plate from the small pieces, and it will be automatically poured into the collection box immediately. Not enough to impress but very functional.
3. When driving the pulley in precision CNC machining, the pulley often slides between the pulley and the shaft. Draw a series of sockets on the shaft with a 15~18mm trocar. This creates a suction force to prevent slipping and turns waste into treasure, increasing its long-term value.
4. In CNC machining, the jaws of the vise need to be removed, and two M4 threaded holes, two with jaws and 1.5mm thick steel plates, and 0.8mm thick hard brass plates with aluminum countersunk head rivets Riveted, hard brass plates are fastened to the jaws with M4 countersunk screws to form a durable soft jaw. This also protects precision parts from being pinched and can be reused. It is a place to protect the details of the appearance of precision CNC machining.