+86-15986734051

What Are The Requirements For Material Quality in Precision Parts Processing?

Jul 23, 2022

What are the requirements for material quality in precision parts processing? In the process of manufacturing precision parts, due to the different production requirements and conditions of various parts, their manufacturing process schemes are also different. When the same parts are produced by different process schemes, their production efficiency and economic benefits are also different.


Under the premise of ensuring the quality of the parts, the process of drawing up a reasonable and feasible process plan with good comprehensive technical and economic benefits is called the process design of the parts. Furthermore, there are certain requirements for the selection and quality of materials.


Precision machining, not all materials can be precision machined, some materials are too hard, exceeding the hardness of the machined parts, it may break the parts, so these materials are not suitable for precision machining, unless it is special Parts made of material, or laser cutting.


Materials for precision machining are divided into two categories, metallic materials and non-metallic materials. For metal materials, the hardness is stainless steel the highest, followed by cast iron, followed by copper, and finally aluminum. The processing of ceramics, plastics, etc. belongs to the processing of non-metallic materials.


The requirements for the hardness of the material, in some cases, the higher the hardness of the material, the better, but it is limited to the hardness requirements of the machined parts. The material to be processed cannot be too hard. The material is moderately soft and hard, which is at least one grade lower than the hardness of the parts. At the same time, it also depends on the function of the processed devices and the reasonable selection of materials for the parts.


Precision machining still has some requirements for materials, not all materials are suitable for processing, such as materials that are too soft or too hard, the former is not necessary for processing, while the latter cannot be processed.


Therefore, you must pay attention to the density of the material before processing. If the density is too high, it is equivalent to a high hardness. If the hardness exceeds the hardness of the machine parts (lathe turning tools), it cannot be processed, which will not only damage the parts, but also It will cause danger, such as the knife flying out and hurting people. Therefore, in general, for mechanical processing, the material quality should be lower than the hardness of the machine tool, so that it can be processed


Send Inquiry