The process of precision CNC machining requires strict confirmation
1. Before processing each program in precision CNC machining, it is necessary to strictly confirm whether the tool is consistent with the program;
2. When installing the tool, it is necessary to confirm whether the length of the tool and the selected clamping tool head are suitable;
3. It is forbidden to open the door during the operation of the machine tool to avoid flying knives or flying workpieces;
4. In the process of precision CNC machining, if the operator finds a tool collision, the operator must stop immediately, such as pressing the "emergency stop" button or "reset key" button or setting the "feed rate" to zero, etc.;
5. In the same workpiece, it needs to be kept in the same area every time the tool is set to ensure the accuracy of the CNC machining center operation rules when the tool is connected;
6. In the process of precision CNC machining, if you find that the machining allowance is too much, you must use "single segment" or "pause" to clear the X, Y, Z values, then manually mill them out, and then shake it back to "zero point" to let it go. it operates on its own;
7. The operator of the cnc machining center manufacturer shall not leave the machine tool or check the operation status of the machine tool regularly during the operation of the CNC machining center manufacturer.
8. The aluminum slag in the machine tool needs to be cleaned before oil injection with the light knife to prevent the aluminum slag from absorbing oil;
9. Try to blow with air in the roughing program, and spray oil in the light knife program;
10. After the workpiece is off the machine, it must be cleaned and deburred in time;
11. When off work, the operator must do a timely and accurate handover to ensure that the subsequent processing can be carried out normally;
12. Before shutting down, ensure that the tool magazine is in the original position, the XYZ axis stops in the center position, and turn off the power supply and the main power supply on the machine tool operation panel in turn;
13. In case of thunderstorm, the power must be cut off immediately to stop working.