Fine parts processing is a CNC equipment that completes various processes in an automatic state, mainly for some fixed and large-scale production operations. But for the mold industry and small-batch consumer units, don't go to the machining center at any time. Many manufacturers buy machining centers to use as CNC milling.
Using the tool magazine is very simple in terms of the cost of the CNC system, but the spindle and tool magazine, air compressors and various tool holders will increase the cost, and programming and adjusting the tool magazine will also take corresponding time. Therefore, try not to use the machining center for the production of less than one or two hundred workpieces of the same type, because the cost is high and the efficiency is low.
For the processing of fine parts, the automatic tool setting system can be used, the tool is installed upwards, a button, the machine tool automatically sets the tool, and the direct processing is performed. The error is within 0.001 ~ .0003mm, which is not much slower than the automatic change time. If it is a precision parts machining center, but a machine tool without automatic tool setting is compared with a machine tool without a tool magazine but with automatic tool setting, the theoretical efficiency of the latter is much higher than the former.